High-country-tek HGC-2, Closed Loop Controller Manuale Utente Scaricare il pdf (Pagina 22)

Hydraulic Generator Controller – HGC-2

HGC-2 Module Connection notes:-

1. Ensure that the recommended fuses ( FS1 & FS2 ) is installed in the system for full protection and warranty.

2. Use separate cables for each connection as shown above.

3. Connect proportional valve coil cables and run separate from all/any high voltage wires.

4. Ensure that high voltage feedback cable is protected to prevent insulation wear during usage through vibration

Electrical System Connections:

Pin Function

1 +VDC Input Supply

2 0VDC Input Supply

3 +Solenoid Connection O/P

4 -Solenoid Connection O/P

5 AC feedback Neutral I/P

6 AC feedback Line I/P

7 Constant Current Mode enable I/P

8 Controller ENABLE I/P

Beware of HIGH VOLTAGE when operating any

generator system – high voltage can be LETHAL –

observe ALL laws, by-laws and health & Safety

recommendations for your immediate location,

state and/or country.

1 2 ... 17 18 19 20 21 22 23 24

Nessun commento

High-country-tek HGC-2, Closed Loop Controller Manuale Utente Pagina 22