High-country-tek HFS-J-Bus Manuale Utente Pagina 6

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
  • Pagina
    / 33
  • Indice
  • SEGNALIBRI
  • Valutato. / 5. Basato su recensioni clienti
Vedere la pagina 5
Electronic Controller Solutions for the Global Fluid Power Industry
Hydraulic Fan System Controller with SAE J1939 Interface
HFS-J User Guide
Part No:- 021-00158 Rev C HFS-J Hydraulic Fan System Controller User Guide Page | 6
Product Overview
NO software experience needed to apply this controller successfully.
Pre-written ‘Fan Drive’ software for easy, fast system configuration, development and production.
Intuitive Graphical User Interface ( GUI ) runs on any PC with Windows® XP or newer software ( .net compatible ).
9 to 32VDC operation with full reverse polarity and
SAE J1455 protection
.
Extended -40ºC ( -40ºF ) to +85ºC ( +185ºF ) controller operational temperature range.
CE approved
to latest international test standards.
J1939 CAN Bus communications
for engine and temperature zone data Inputs
**
J1939 temperature data hard coded for :
Engine water/coolant at PGN 65262,
Transmission Oil temperature at PGN 65272
Intake manifold/charge air Temperature at PGN 65270
All inputs and outputs protected from shorting to ground or the power supply.
Diagnostic LED display shows I/O status and module operation at a glance.
‘Blinking’ error code LED for fast on-site ‘health check’.
System wiring and coil fault detection and alarms.
Alarm output for integration into host system.
IP68 (NEMA 6P)
rating on module for harsh environment reliability ( connector IP rating may differ ).
Single Deutsch Metri-pack 150 series I/O 12 way connector for easy system wiring.
Separate RS232 communications connector for programming, monitoring and diagnostics.
Rugged encapsulated product withstands harsh environments found in mobile applications.
Non Volatile Memory maintains ALL settings without power
Completely user configurable for setting confidentiality.
Compatible with all manufacturers fan system hydraulic valve and pump control products.
**J1939 Temperature Data NOTE:-
If the J1939 PGN data for temperature is NOT correct for a particular engine, HCT can change the PGN number
to one that is correct and re-issue the program code to you. Please use the contact numbers on the back page
of this manual to discuss this with our customer support personel.
Vedere la pagina 5
1 2 3 4 5 6 7 8 9 10 11 ... 32 33

Commenti su questo manuale

Nessun commento